Iowa Precision Cornermatic Plus® Versa HVAC Ductwork Corner Inserter Machine

The Iowa Precision Cornermatic Plus Versa HVAC Ductwork Corner Inserter Machine is the most flexible unit of its kind for production available. While the Iowa Precision Cornermatic Plus HVAC Ductwork Corner Insertion Machine was specifically designed to handle any transverse duct connector (TDC) or transverse duct flange (TDF) fitting assembled on a bench and automatically and effortlessly insert and crimp Iowa Precision TDC and TDF Corners in seconds — allowing you to do a duct section — eight (8) corners — in about 20 seconds in any gauge (16 through 26), the Cornermatic Plus Versa adds the capability of sitting on your workshop floor or in-ground, allowing for greater flexibility during production. The heavy-duty hydraulic scissor lift raises and lowers the machine with a simple press of a button in less than 16 seconds. The in-ground feature is beneficial for projects involving large or straight duct and heavier gauge, larger fittings, while the above-ground position is ideal for fitting production.

New call-to-action

The Iowa Precision Cornermatic Plus Versa HVAC Ductwork Corner Insertion Machine features:

  • Specifically designed for the fabrication of duct fittings — even the toughest inside or outside angle off-set transition fitting from 16-26 gauge
  • Designed to fabricate large and small duct fittings in one machine – including tough inside or outside angle off-set transition fittings
  • Floor level setting allows for sliding over large duct sections and fittings to automatically insert the corners
  • Operator friendly above ground, table height setting is ideal for fabricating small fittings
  • Simple press of a button allows operator to go from in-ground to above ground setting in less than 1 minute
  • Fully automated – no switches or foot pedals – just push in and Cornermatic Plus does the rest
  • Completes eight (8) corner inserts in seconds
  • New quick loading StrapPak™ packaging technology speeds loading and eliminates the need to sort and orient the corners before installation
  • Corners feed from below the work-surface allowing a clean, unobstructed work area
  • Handles tight square throat elbows and flex connectors
  • Works with SMACNA-conforming, T-25a and T-25b flange and many other flanged duct systems without changing settings
  • Corners are inserted square and fully crimped
  • No need to change the crimping adjustment when inserting corners in 16 to 26 gauge ducts
  • Each quick loading box holds 80 corners-loads in ten (10) seconds
  • Corners are shipped presorted and oriented for direct loading into the magazine
  • Adjustable legs to match most bench heights
  • Handles particularly difficult inside angles on off-set transitions with a breeze
  • Easily handles tight square throats
  • Will do odd size fittings such as flex connectors and curbs

Model

Capacity

Depth of Pocket

Other

Speed

Motor / Voltage

Dimensions / Weight

Iowa Precision Cornermatic Plus Versa HVAC Ductwork Corner Inserter Machine
16 to 26 gauge (.062" to .022" / 1.6mm to 0.6mm)
Mild Steel Only
Flange Type for insertion: Transverse Duct Connector (TDC) and/or Transverse Duct Flange (TDF) — Customer to Specify

Model Capacity - Max 80 Corners StrapPak™ Quick-loading sleeve loads in 10 seconds

Approximately 2.5 seconds per corner
Electrical - 110/1/60 (Single Phase)

Air - 85 to 100 PSI (5.5 - 7 Bar)

Length: 32"
Width: 36"
Height: 34"

Weight: 600 lbs.

Iowa Precision Cornermatic Plus Versa HVAC Ductwork Corner Inserter Machine



 
Iowa Precision | Cornermatic Plus Versa HVAC Ductwork Corner Inserter Machine | Features

Related Iowa Precision Products