Engel Swing-Blade HVAC Insulation Cutting System

The Engel Swing-Blade HVAC Insulation Cutting System can be used to cut both the conformable non-fibrous foam insulation and standard fiberglass insulation. This cut-off is a special hardened waved cutting edge knife design that slices the insulation rather than the old chop method. It also uses a patented narrow slot in the cutting stick for the knife to pass thru without touching the cutting stick which increases the life of the knife.

When switching from fiberglass insulation to conformable non-fibrous foam insulation a new knife blade may be required. The fiberglass insulation is very abrasive and will take the fine edge off the knife blade after a period of time. The knife blade will continue to cut and fracture the fiberglass because of the narrow slot in which the knife blade passes through. When switching from conformable non-fibrous foam insulation a new knife blade is not required.

NOTE: ARMA-FLEX™ open-cell forms into corners of duct, cuts to non-stretched lengths, able to be pinned and glued “in-line” and “on-the-fly.” Do not confuse with AP Armaflex closed-cell usable for fittings.

New call-to-action
New call-to-action

Model

Capacity

Depth of Pocket / Size

Minimum Part Length

Speed Cycle Time

Dimensions / Weight

Engel Swing Blade HVAC Insulation Cutting System

1/2″ – 2″ Fiberglass Insulation

1/2″ to 2-1/2″ Elastomeric Foam

48″ and 60″ width

22"

25-50 feet per minute

Length: 84"

Width: 71"

Height: 60"

Weight: 1,850 lbs.

Engel Swing Blade HVAC Insulation Cutting System

Related Engel Products