Lockformer Drive Turn Hemming Machine

The Lockformer Drive Turn Hemming Machine features the Lockformer Skip Dent Indexing Roll which is the heart of the system. The indexer is the first roll and has four pins and two milled ridges. The control lever determines whether the blank is hemmed after the first or second notch. With the lever in position 1, as the blank engages the indexing roll, a pin drops into the first notch. A ridge adjacent to the pin pre-bends the material at its corner just enough to force the material into the hem forming rolls where the 180 degree hem is formed. The next pin, on the rotating index roll, drops into the second notch and since there is no ridge present, the corner of the blank is not turned down and misses the hemming rolls and this section remains unformed.

New call-to-action
New call-to-action

Model

Capacity

Depth of Pocket / Size

Speed

Motor / Voltage

Dimensions / Weight

Lockformer Drive Turn Hemming Machine
22-26 gauge
Uses approximately 1/2" Hem material

60 feet per minute

3 hp, 230/460 volts, 60 cycle, 3 phase, A.C. 3,600 RPM

Length: 42-3/4"
Width: 70"
Height: 33-3/16"
Weight: 1,650 lbs.

Related Lockformer Products

Related Products from Other Mestek Machinery Brands