Beading is a cost-conscious way to stiffen ductwork. It is 5 times faster than cross-braking and uses only one operator. The Lockformer Beader 6016 Beading Roll Former was designed to meet the requirements of SMACNA — producing five (5) beads on 12″ centers and is adjustable to 3/16″ depth. The machine features a convenient hand-wheel to raise or lower the top roll assembly to set depth of bead. The top and bottom rollers are kept parallel with adjustable screw and pillow block assemblies connected by a link chain. Individual adjustable screw and pillow block assemblies connected by a link chain. Individual collared beading rolls are replaceable. Feed rolls are self-compensating over the entire gauge range. Double entrance feed bars are provided so that material can be gauged from either left or right side.
With Lockformer quality construction, this machine also features:
- Industrial electric motor
- Precision bearings
- Turned, ground, and polished steel forming rolls and roll shafts
- Arc-welded steel stand protected with Lockformer top-quality primer and paint finish
- Lubrication fittings are located on each bearing
Motor / Voltage
Dimensions / Weight
6016 Beading Roll Former
115/230 volts, 60 cycle, single phase,
Max Width: 5'
Lockformer | Beader 6016 Beading Roll Former