Lockformer HVAC Ductwork Auto-Guide Flanging Machine | Model 16

The Lockformer HVAC Ductwork Auto-Guide Flanging Machine | Model 16 automatically follows any edge – curved or straight — and uses the convenient table slot to automatically turn up a “starting flange”. A calibrated dial can be set for radii as small as 3-1/4″ (or 2″ when auto-guide is deactivated). Automatically flange 16 to 26 gauge material at speeds of 18 fpm. A non-releasing type head is suitable for open-end fittings, straight and irregular curves. Standard with Lockformer quality construction, this machine has an industrial electric motor, and an arc-welded steel stand protected with Lockformer’s top-quality primer and paint finish.

New call-to-action

Model

Capacity

Depth of Pocket / Size

Speed

Motor / Voltage

Dimensions / Weight

Lockformer HVAC Ductwork Auto-Guide Flanging Machine | Model 16
16 gauge maximum. Working range 16-24 gauge
Two flange heights available. Specify 3/8" or 1/4"

18 feet per minute

3/4 hp, 115/230 volts, 60 cycle, single phase, A.C. 1,800 RPM

Length: 24"
Width: 24"
Passline: 34"
Weight: 225 lbs.

Lockformer HVAC Ductwork Auto-Guide Flanging Machine | Model 16