Iowa Precision Cornermatic Plus® Automated HVAC Ductwork Corner Inserter Machine
The Iowa Precision Cornermatic Plus Automated Corner Insertion Machine was specifically designed to reduce shop labor by addressing the difficulty with inserting corners into duct FITTINGS — from standard fittings to odd fittings like tight square throat elbows, flex connectors, offsets down to 2″ throats, and even the toughest inside or outside angle off-set transition fitting from 16-26 gauge. Sitting at an ergonomically comfortable table height, the Cornermatic Plus The Cornermatic Plus can handle any transverse duct connector (TDC) or transverse duct flange (TDF) fitting assembled on a bench and automatically and effortlessly completes eight (8) transverse duct connector (TDC) or transverse duct flange (TDF corner inserts — square and fully crimped — in approximately 20 seconds.
For additional flexibility, see the Cornermatic Plus Versa Automated Corner Insertion Machine which features the same above ground, ergonomic table height setting as the Cornermatic Plus, but also adds a floor level setting which allows for sliding over larger, heavier fittings and cut duct sections (machine goes from in-ground to above ground in less than 1 minute with a simple push of a button).
Features of the Iowa Precision Cornermatic Plus HVAC Ductwork Corner Insertion Machine:
- Specifically designed for the fabrication of duct fittings from 16-26 gauge — from standard fittings to odd fittings like tight square throat elbows, flex connectors, offsets down to 2″ throats, and even the toughest inside or outside angle off-set transition fitting
- Completes eight (8) corner inserts in seconds
- Operator friendly above ground, table height setting is ideal for fabricating small fittings — adjustable legs to match most bench heights
- Heavy gauge switch for 16-18 gauge performance and light gauge switch for 20-26 gauge performance enhances the crimping process — slows the Cornermatic down for heavy gauge and speeds it up for light gauge
- Fully automated — no switches or foot pedals — just push in and Cornermatic does the rest
- Corners are inserted square and fully crimped — no need to change the crimping adjustment when inserting corners in 16 to 26 gauge fittings
- Corners feed from below the work-surface allowing a clean, unobstructed work area
- Light bar indicates when the material has fully engaged on the right or left side of the infeed guide clamps — green light = Go, red light = No
- Light bar also indicates empty corner magazine
- Works with SMACNA-conforming, T-25a and T-25b flange and many other flanged duct systems without changing settings
- Each quick loading box holds eigthy (80) corners and loads in ten (10) seconds
Model Capacity Depth of Pocket Other Speed Motor / Voltage Dimensions / Weight Model Capacity - Max 80 Corners StrapPak™ Quick-loading sleeve loads in 10 seconds Length: 32" Weight: 600 lbs.
Iowa Precision Cornermatic Plus HVAC Ductwork Corner Inserter Machine16 to 26 gauge (.062" to .022" / 1.6mm to 0.6mm)
Mild Steel OnlyFlange Type for insertion: Transverse Duct Connector (TDC) and/or Transverse Duct Flange (TDF) — Customer to SpecifyApproximately 2.5 seconds per cornerElectrical - 110/1/60 (Single Phase)
Air - 85 to 100 PSI (5.5 - 7 Bar)
Width: 36"
Height: 34"
Iowa Precision Cornermatic Plus HVAC Ductwork Corner Inserter Machine
Iowa Precision | Improving the Shop Floor Layout of your HVAC Duct and Fittings Fabrication Operation for Maximum Productivity | Preview
Iowa Precision | Improving the Shop Floor Layout of your HVAC Duct and Fittings Fabrication Operation for Maximum Productivity | Registration Required
Iowa Precision | Cornermatic Plus HVAC Ductwork Corner Inserter Machine | Features & Tutorial
